ASROCK K7NF2-RAID Datasheet download pdf (Page 22)

2222

Chapter 3 BIOS SETUP UTILITYChapter 3 BIOS SETUP UTILITY

Chapter 3 BIOS SETUP UTILITY

3.13.1

3.1

IntroductionIntroduction

Introduction

This section explains how to use the BIOS SETUP UTILITY to configure your system.

The Flash Me mory on the motherboard stores the BIOS SETUP UTILITY. You may run

the BIOS SETUP UTILITY when you start up the computer. Ple ase pre ss <F2> during

the Power-On-Self-Test (POST) to enter the BIOS S ETUP UTILITY, otherwise, POST

will continue with its test routines.

If you wish to enter the BIOS SETUP UTILITY after POST, restart the system by

pressing <Ctl> + <Alt> + <Delete>, or by pressing the reset button on the system

chassis. Y ou may also re start by turning the syste m of f and then back on.

Because the BIOS software is constantly being updated, the

following BIOS setup screens and descriptions are for refer-

ence purpose only, and they may not exactly match what you

see on your screen.

3.1.13.1.1

3.1.1

BIOS Menu BarBIOS Menu Bar

BIOS Menu Bar

The top of the screen has a menu bar with the f ollowing sele ction s:

Main To set up the syste m ti me/date inf ormation

Advanced To set up the a dva nced BIOS feature s

PCIPnP To set up the PCI fe ature s

Boot To set up the default syste m device to locate a nd loa d the

Operating System

Security To set up the se curity fe ature s

Chipset To set up the chi pset fe ature s

Exit To exit the current screen or the BIOS SETUP UTILITY

Use < > key or < > key to choose among the sele ction s on the menu bar,

and then press <Enter> to get into the sub screen.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 35 36

No comments

ASROCK K7NF2-RAID Datasheet Page 22