ASROCK K7NF2-RAID Datasheet download pdf (Page 16)

1616

2.8 Connectors2.8 Connectors

2.8 Connectors

Connectors are N O T jumpers. D O N O T place jumper caps over

the se conne ctors. Pla cing jumper caps over the conne ctors will

cause permanent damage of the motherboard!

FD D Connector

(33-pin FLOPPY1)

(see p.8 item 18)

Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the

connector.

Primary IDE Connector (Blue) S e condary IDE Connector (Bla ck)

(39-pin IDE1, see p.8 ite m 11) (39-pin IDE2, see p.8 item 12)

Note: If you use only one IDE device on this motherboard, ple ase set the IDE

device as “M aster”. Ple a se refer to the in struction of your IDE device vendor

for the details. Be side s, to opti mize compatibility and perf ormance, ple ase

connect your hard disk drive to the primary IDE connector (IDE1, blue) and

CD-ROM to the secondary IDE connector (IDE2, bla ck).

Seri al ATA Connectors T h e se two Seri al A TA (SATA)

(SATA1: see p.8 ite m 9) connectors support SATA data

(SATA2: see p.8 ite m 8) cables for internal storage

device s. The current SATA

interfa ce allows up to 1.5 Gb/s

data transfer rate.

Seri al A TA (SA TA) Either end of the SATA data ca ble

Data Cable can be connected to the SATA

hard dis k or the SATA conne ctor

on the motherboard.

FLOPPY1

Pin1

IDE1

PIN1

IDE2

PIN1

connect the bla ck end

to the IDE devices

connect the blue end

to the motherboard

80-conductor A TA 66/100/133 cable

the red-striped side to Pin1

SATA1

SATA2

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 35 36

No comments

ASROCK K7NF2-RAID Datasheet Page 16