ASROCK K7NF2-RAID Datasheet download pdf (Page 10)

1010

Chapter 2 InstallationChapter 2 Installation

Chapter 2 Installation

K7NF2-RAID is an A TX f orm factor (12.0-in x 7.8-in, 30.5-cm x 19.8-cm) motherboard.

Bef ore you in stall the motherboard, study the conf iguration of your cha ssis to en-

sure that the motherboard fits into it.

Make sure to unplug the power cord before installing or

removing the motherboard. Failure to do so may cause physical

injurie s to you a nd damages to motherboard components.

2.1 Screw Holes2.1 Screw Holes

2.1 Screw Holes

Place screws into the hole s indicated by circle s to se cure the motherboard to the

c h a ssis.

Do not over-tighten the screws! Doing so may damage the

motherboard.

2.2 Pre-installation Precautions2.2 Pre-installation Precautions

2.2 Pre-installation Precautions

Take note of the f ollowing pre caution s before you in stall motherboard components

or change any motherboard settings.

1. U nplug the power cord from the wall socket bef ore touching a ny

component.

2. To avoid damaging the motherboard components due to static

ele ctricity, NEVER place your motherboard dire ctly on the carpet or

the like. Also re m e mber to use a grounded wrist strap or touch a

safety grounded object before you handle components.

3. Hold components by the edges and do not touch the ICs.

4. Whenever you uninstall any component, place it on a grounded

antistatic pad or in the bag that comes with the component.

Before you install or remove any component, ensure that the

power is switched off or the power cord is detached from the

power supply. Failure to do so may cause severe damage to

the motherboard, peripherals, and/or components.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 35 36

No comments

ASROCK K7NF2-RAID Datasheet Page 10