Asrock Fatal1ty H87 Performance User Manual download pdf (Page 28)

English

2.6 Onboard Headers and Connectors

System Panel Header

(9-pin PANEL1)

(see p.1, No. 11)

Connect the power

switch, reset switch and

system status indicator on

the chassis to this header

according to the pin

assignments below. Note

the positive and negative

pins before connecting

the cables.

GND

R ESET#

P WRBTN#

P LED-

P LED+

GND

H DLED-

H DLED+

GND

PWRBTN (Power Switch):

Connect to the power switch on the chassis front panel. You may congure the way to

turn o your system using the power switch.

RESET (Reset Switch):

Connect to the reset switch on the chassis front panel. Press the reset switch to restart

the computer if the computer freezes and fails to perform a normal restart.

PLED (System Power LED):

Connect to the power status indicator on the chassis front panel. e LED is on when

the system is operating. e LED keeps blinking when the system is in S1/S3 sleep state.

e LED is o when the system is in S4 sleep state or powered o (S5).

HDLED (Hard Drive Activity LED):

Connect to the hard drive activity LED on the chassis front panel. e LED is on when

the hard drive is reading or writing data.

e front panel design may dier by chassis. A front panel module mainly consists

of power switch, reset switch, power LED, hard drive activity LED, speaker and etc.

When connecting your chassis front panel module to this header, make sure the wire

assignments and the pin assignments are matched correctly.

Onboard headers and connectors are NOT jumpers. Do NOT place jumper caps over

these headers and connectors. Placing jumper caps over the headers and connectors

will cause permanent damage to the motherboard.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 164 165

Comments to this Manuals

No comments

Asrock Fatal1ty H87 Performance User Manual Page 28

Comments to this Manuals

Related products and manuals for Motherboard Asrock Fatal1ty H87 Performance