ASROCK P4DUAL-915GL Datasheet download pdf (Page 18)

1818

FLOPPY1

Pin1

IDE1

PIN1

the red-striped side to Pin1

connect the black end

to the IDE devices

connect the blue end

to the motherboard

80-conductor ATA 66/100 cable

2.7 Onboard Headers and Connectors2.7 Onboard Headers and Connectors

2.7 Onboard Headers and Connectors

Onboard headers and connectors are NOT jumpers. Do NOT place

jumper caps over these headers and connectors. Placing jumper caps

over the headers and connectors will cause permanent damage of the

motherboard!

FDD connector

(33-pin FLOPPY1)

(see p.11 No. 9)

Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the

connector.

Primary IDE connector (Black)

(39-pin IDE1, see p.11 No. 10)

Note: Please refer to the instruction of your IDE device vendor for the details.

Serial ATA Connectors These four Serial ATA (SATA)

(SATA1: see p.11 No. 18) connectors support SATA data

(SATA2: see p.11 No. 17) cables for internal storage

(SATA3: see p.11 No. 16) devices. The current SATA

(SATA4: see p.11 No. 15) interface allows up to 1.5 Gb/s

data transfer rate.

Serial ATA (SATA) Either end of the SATA data cable

Data Cable can be connected to the SATA

hard disk or the SATA connector

on the motherboard.

SATA1 SATA2 SATA3 SATA4

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 36 37

No comments

ASROCK P4DUAL-915GL Datasheet Page 18