ASROCK 945GCM-S Installation Guide download pdf (Page 17)

2.6 Onboard Headers and Connectors

Onboard headers and connectors are NOT jumpers. Do NOT place

jumper caps over these headers and connectors. Placing jumper caps

over the headers and connectors will cause permanent damage of the

motherboard!

FDD connector

(33-pin FLOPPY1)

(see p.2 No. 20)

IPINI FLOPPY1

the red-striped side to Pin1

Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the

connector.

Primary IDE connector (Blue)

(39-pin IDE1, see p.2 No. 7)

IPIN1

IDE1

connect the blue end -j-—т^ГЛ connect the black end

to the motherboard V^® ^iV to the IDE devices

80-conductor ATA 66/100 cable

Note: Please refer to the instruction of your IDE device vendor for the details.

Serial ATAII Connectors

(SATAIM: see p.2, No. 13)

(SATAII_2: see p.2, No. 12)

(SATAII_3: see p.2, No. 10)

(SATAll_4: see p.2, No.11)

These Serial ATAII (SATAN)

connectors support SATAN

or SATA hard disk for internal

storage devices. The current

SATAN interface allows up to

3.0 Gb/s data transfer rate.

Serial ATA (SATA)

Data Cable

(Optional)

Either end of the SATA data cable

can be connected to the SATA /

SATAN hard disk or the SATAII

connector on the motherboard.

Serial ATA (SATA)

Power Cable

(Optional) I

connect to the SATA

HDD power connector

connect to the

power supply

Please connect the black end of

SATA power cable to the power

connector on each drive. Then

connect the white end of SATA

power cable to the power

connector of the power supply.

AS Rock 945GCM-S Motherboard

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23

Comments to this Manuals

No comments

ASROCK 945GCM-S Installation Guide Page 17

Comments to this Manuals

Related products and manuals for Motherboards ASROCK 945GCM-S