ASROCK 945GCM-S Installation Guide

12. While CPU overheat is detected, the system will automatically shutdown. Before you resume the system, please check if the CPU fan on the motherboa

2. Installation Pre-installation Precautions Take note of the following precautions before you install mother-board components or change any motherboa

Step 1. Open the socket: Step 1-1. Disengaging the lever by depressing down and out on the hook to clear retention tab. Step 1 -2. Rotate the load lev

1. It is recommended to use the cap tab to handle and avoid kicking off the PnP cap. 2. This cap must be placed if returning the motherboard for after

2.3 Installation of Memory Modules (DIMM) 945GCM-S motherboard provides two 240-pin DDR2 (Double Data Rate 2) DIMM slots, and supports Dual Channel Me

2.4 Expansion Slots (PCI and PCI Express Slots) There are 2 PCI slots and 2 PCI Express slots on this motherboard. PCI slots: PCI slots are used to in

2.5 Jumpers Setup The illustration shows how jumpers are setup. When the jumper cap is placed on pins, the jumper is "Short". If no jumper c

2.6 Onboard Headers and Connectors Onboard headers and connectors are NOT jumpers. Do NOT place jumper caps over these headers and connectors. Placing

USB 2.0 Headers (9-pin USB6_7) (see p.2 No. 15) (9-pin USB4_5) (see p.2 No. 16) • GND g"" гЫ-г l+l 1 GND Besides four default USB 2.0 ports

D. MIC_RET and OUT_RET are for HD audio panel only. You don't need to connect them for AC'97 audio panel. E. Enter BIOS Setup Utility. Enter

Pin Header Easy Installation Guide ASRock motherboard is equipped with pin headers with obvious colors which indicate you to recognize the crucial hea

A Though this motherboard provides 4-Pin CPU fan (Quiet Fan) support, the 3-Pin CPU fan still can work successfully even without the fan speed control

2.7 Serial ATA (SATA) / Serial ATAII (SATAII) Hard Disks Installation This motherboard adopts Intel® ICH7 south bridge chipset that supports Serial AT

3. BIOS Information The Flash Memory on the motherboard stores BIOS Setup Utility. When you start up the computer, please press <F2> during the

www.asrock.com P/N : 1 5G06X275000AK VI .0

Copyright Notice: No part of this installation guide may be reproduced, transcribed, transmitted, or trans-lated in any language, in any form or by an

Motherboard Layout 10 11 12 13 14 PS2_USB_PWR1 Jumper 775-Pin CPU Socket North Bridge Controller CPU Fan Connector (CPU_FAN1) 2 X 240-pin DDR2 DIMM Sl

HO Panel 10 1 PS/2 Mouse Port (Green) 2 USB 2.0 Ports (USB23) 3 RJ-45 Port 4 Line In (Light Blue) 5 Line Out (Lime) 6 Microphone (Pink) 7 USB 2.0 Port

1. Introduction Thank you for purchasing ASRock 945GCM-S motherboard, a reliable motherboard produced under ASRock's consistently stringent quali

1.2 Specifications Platform - Micro ATX Form Factor: 9.6-in x 7.5-in, 24.4 cm x 19.1 cm CPU - LGA 775 for Intel® Dual Core Core™ 2 Extreme / Core™ 2

-1 x Print port header - CPU/Chassis FAN connector - 24 pin ATX power connector - 4 pin 12V power connector - CD in header - Front panel audio connect

1. FSB1333-CPU will operate in overclocking nlode. Under this situation, PCIE frequency will also be overclocked to 115MHz. Besides, if you want to ov