ASROCK N68-GS3 FX Owner's Manual download pdf (Page 20)

2020

FLOPPY1

Pin1

the red-striped side to Pin1

2.7 Onboard Headers and Connectors2.7 Onboard Headers and Connectors

2.7 Onboard Headers and Connectors

Onboard headers and connectors are NOT jumpers. Do NOT place

jumper caps over these headers and connectors. Placing jumper caps

over the headers and connectors will cause permanent damage of the

motherboard!

•

Floppy Connector

(33-pin FLOPPY1)

(see p.11 No. 20)

Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the

connector.

Primary IDE connector (Blue)

(39-pin IDE1, see p.11 No. 6)

Note: Please refer to the instruction of your IDE device vendor for the details.

Serial ATAII Connectors These four Serial ATAII (SATAII)

(SATAII_1 (PORT 0.0): connectors support SATAII

see p.11, No. 9) or SATA hard disk for internal

(SATAII_2 (PORT 0.1): storage devices. The current

see p.11, No. 5) SATAII interface allows up to

(SATAII_3 (PORT 1.0): 3.0 Gb/s data transfer rate.

see p.11, No. 8)

(SATAII_4 (PORT 1.1):

see p.11, No. 7)

Serial ATA (SATA) Either end of the SATA data cable

Data Cable can be connected to the SATA /

(Optional) SATAII hard disk or the SATAII

connector on the motherboard.

connect the black end

to the IDE devices

connect the blue end

to the motherboard

IDE1

PIN1

80-conductor ATA 66/100/133 cable

SATAII_3 SATAII_1

(PORT 1.0) (PORT 0.0)

SATAII_4 SATAII_2

(PORT 1.1) (PORT 0.1)

after you update the BIOS. If you need to clear the CMOS when you just finish

updating the BIOS, you must boot up the system first, and then shut it down

before you do the clear-CMOS action.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 51 52

Comments to this Manuals

No comments

ASROCK N68-GS3 FX Owner's Manual Page 20

Comments to this Manuals

Related products and manuals for Motherboards ASROCK N68-GS3 FX