ASROCK FM2A85X Extreme4-M User Manual download pdf (Page 35)

USB 2.0 header

(9-pin, black)

CIR header

(4-pin, gray)

2.8 ASRock Smart Remote Installation Guide

ASRock Smart Remote is only used for ASRock motherboards with a CIR

header. Please refer to the procedures below for the quick installation and

usage of ASRock Smart Remote.

Step1. Find the CIR header located

next to the USB 2.0 header on

your ASRock motherboard.

Step2. Connect the front USB cable to

the USB 2.0 header (as below,

pin 1-5) and the CIR header.

Please make sure the wire

assignments and the pin

assignments are matched

correctly.

USB_PWR

P-

P+

GND

ATX+5VSB

IRRX

IRTX

GND

DUMMY

Step3. Install the Multi-Angle CIR Receiver to the front USB port.

Step4. Boot up your system. Press <F2> or <Del> to enter the BIOS

Setup Utility. Make sure the option "CIR Controller" is set to

[Enabled]. (Advanced -> Super IO Conguration -> CIR Controller

-> [Enabled])

If you cannot nd this option, please shut down your system

and install the Multi-Angle CIR Receiver to the other front USB

port then try again.

Step5. Enter Windows. Execute ASRock's support CD and install the

CIR Driver. (It is listed at the bottom of driver list.)

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 82 83

No comments

ASROCK FM2A85X Extreme4-M User Manual Page 35