ASROCK M3A790GXH/128M User Manual download pdf (Page 35)

3535

FLOPPY1

Pin1

the red-striped side to Pin1

2.9 Onboard Headers and Connectors2.9 Onboard Headers and Connectors

2.9 Onboard Headers and Connectors

Onboard headers and connectors are NOT jumpers. Do NOT place

jumper caps over these headers and connectors. Placing jumper caps

over the headers and connectors will cause permanent damage of the

motherboard!

•

Floppy Connector

(33-pin FLOPPY1)

(see p.14 No. 31)

Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the

connector.

Primary IDE connector (Blue)

(39-pin IDE1, see p.14 No. 12)

Note: Please refer to the instruction of your IDE device vendor for the details.

Serial ATAII Connectors These six Serial ATAII (SATAII)

(SATAII_1: see p.14, No. 17) connectors support SATAII

(SATAII_2: see p.14, No. 18) or SATA hard disk for internal

(SATAII_3: see p.14, No. 20) storage devices. The current

(SATAII_4: see p.14, No. 19) SATAII interface allows up to 3.0

(SATAII_5: see p.14, No. 22) Gb/s data transfer rate.

(SATAII_6: see p.14, No. 23)

connect the black end

to the IDE devices

connect the blue end

to the motherboard

IDE1

PIN1

80-conductor ATA 66/100/133 cable

SATAII_6 connector can be used for internal storage device or be

connected to eSATAII connector to support eSATAII device. Please

read “eSATAII Interface Introduction” on page 43 for details about

eSATAII and eSATAII installation procedures.

eSATAII Connector This eSATAII connector

(eSATAII_TOP: see p.14, No. 42) supports SATA data cable for

external SATAII function. The

current eSATAII interface

allows up to 3.0 Gb/s data

transfer rate.

SATAII_6 SATAII_5

SATAII_1 SATAII_2

SATAII_3 SATAII_4

eSATAII_TOP

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 79 80

Comments to this Manuals

No comments

ASROCK M3A790GXH/128M User Manual Page 35

Comments to this Manuals

Related products and manuals for Motherboards ASROCK M3A790GXH/128M