ASROCK 4Core1600-GLAN User Manual download pdf (Page 20)

2020

2.8 Onboard Headers and Connectors2.8 Onboard Headers and Connectors

2.8 Onboard Headers and Connectors

Onboard headers and connectors are NOT jumpers. Do NOT place

jumper caps over these headers and connectors. Placing jumper caps

over the headers and connectors will cause permanent damage of the

motherboard!

FDD connector

(33-pin FLOPPY1)

(see p.10 No. 23)

Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the

connector.

Primary IDE connector (Blue)

(39-pin IDE1, see p.10 No. 9)

Note: Please refer to the instruction of your IDE device vendor for the details.

Serial ATAII Connectors These four Serial ATAII (SATAII)

(SATAII_1 (Port0): connectors support SATA data

see p.10, No. 17) cables for internal storage

(SATAII_2 (Port1): devices. The current SATAII

see p.10, No. 16) interface allows up to 3.0 Gb/s

(SATAII_3 (Port2): data transfer rate.

see p.10, No. 14)

(SATAII_4 (Port3):

see p.10, No. 13)

FLOPPY1

Pin1

the red-striped side to Pin1

connect the black end

to the IDE devices

connect the blue end

to the motherboard

IDE1

PIN1

SATAII_1 (Port0) SATAII_4 (Port3)

80-conductor ATA 66/100 cable

SATAII_2 (Port1) SATAII_3 (Port2)

Serial ATA (SATA) Either end of the SATA data cable

Data Cable can be connected to the SATA /

(Optional) SATAII hard disk or the SATAII

connector on this motherboard.

Serial ATA (SATA) Please connect the black end of

Power Cable SATA power cable to the power

(Optional) connector on each drive. Then

connect the white end of SATA

power cable to the power

connector of the power supply.

connect to the SATA

HDD power connector

connect to

the power

supply

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 42 43

Comments to this Manuals

No comments

ASROCK 4Core1600-GLAN User Manual Page 20

Comments to this Manuals

Related products and manuals for Motherboards ASROCK 4Core1600-GLAN