ASROCK 880GM-LE FX Installation Guide download pdf (Page 21)

2121

ASRock 880GM-LE FX Motherboard

EnglishEnglish

English

2.8 Onboard Headers and Connectors2.8 Onboard Headers and Connectors

2.8 Onboard Headers and Connectors

Onboard headers and connectors are NOT jumpers. Do NOT place

jumper caps over these headers and connectors. Placing jumper

caps over the headers and connectors will cause permanent dam-

age of the motherboard!

•

Floppy Connector

(33-pin FLOPPY1)

(see p.2 No. 25)

Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the

connector.

Primary IDE connector (Blue)

(39-pin IDE1, see p.2 No. 10)

Note: Please refer to the instruction of your IDE device vendor for the details.

Serial ATAII Connectors These six Serial ATAII (SATAII)

(SATAII_1 (PORT 0): connectors support SATAII

see p.2, No. 19) or SATA hard disk for internal

(SATAII_2 (PORT 1): storage devices. The current

see p.2, No. 18) SATAII interface allows up to

(SATAII_3 (PORT 2): 3.0 Gb/s data transfer rate.

see p.2, No. 17)

(SATAII_4 (PORT 3):

see p.2, No. 13)

(SATAII_5 (PORT 4):

see p.2, No. 12)

(SATAII_6 (PORT 5):

see p.2, No. 11)

Serial ATA (SATA) Either end of the SATA data cable

Data Cable can be connected to the SATA /

(Optional) SATAII hard disk or the SATAII

connector on the motherboard.

connect the black end

to the IDE devices

connect the blue end

to the motherboard

80-conductor ATA 66/100/133 cable

the red-striped side to

Pin1

SATAII_4 SATAII_5 SATAII_6

(PORT 3) (PORT 4) (PORT 5)

SATAII_1 SATAII_2 SATAII_3

(PORT 0) (PORT 1) (PORT 2)

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 176 177

Comments to this Manuals

No comments

ASROCK 880GM-LE FX Installation Guide Page 21

Comments to this Manuals

Related products and manuals for Motherboards ASROCK 880GM-LE FX