ASROCK 775XFire-eSATA2 Datasheet download pdf (Page 8)

CAUTION!

1. About the setting of “Hyper Threading Technology”, please check page 40.

2. This motherboard supports Untied Overclocking Technology. Please read “Un-

tied Overclocking Technology” on page 37 for details.

3. This motherboard supports Dual Channel Memory Technology. Before you

implement Dual Channel Memory Technology, make sure to read the

installation guide of memory modules on page 16 for proper installation.

4. There are memory module installation limitations on this motherboard,

please read “Installation of Memory Modules (DIMM)” on page 16 for

details.

5. Although this motherboard offers stepless control, it is not recommended

to perform over-clocking. Frequencies other than the recommended CPU

bus frequencies may cause the instability of the system or damage the

CPU.

6. While CPU overheat is detected, the system will automatically shutdown.

Before you resume the system, please check if the CPU fan on the

motherboard functions properly and unplug the power cord, then plug it

back again. To improve heat dissipation, remember to spray thermal

grease between the CPU and the heatsink when you install the PC system.

7. For the information of the compatible PCI Express VGA cards, please

refer to the “Supported PCI Express VGA Card List for AGI Express Slot

(PCI Express x 4)” on page 9. For the proper installation of PCI Express

VGA card, please refer to the installation guide on page 18.

8. Before installing SATAII hard disk to SATAII connector, please read the

“SATAII Hard Disk Setup Guide” on page 31 to adjust your SATAII hard disk

drive to SATAII mode. Besides, you are allowed to downgrade the SATAII

hard disk to SATA hard disk (from SATAII 3Gb/s down to SATA 1.5Gb/s),

and connect it to the SATAII connector. You can also connect SATA hard

disk to SATAII connector directly.

9. This motherboard supports eSATAII interface, the external SATAII

specification. Please read “eSATAII Interface Introduction” on page 28 for

details about eSATAII and eSATAII installation procedures. (Port Multiplier

Technology is not supported with eSATAII interface on this motherboard.)

10. Power Management for USB 2.0 works fine under Microsoft

Windows

SP1 or SP2 / 2000 SP4.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 52 53

No comments

ASROCK 775XFire-eSATA2 Datasheet Page 8