ASROCK 3D Owner's Manual download pdf (Page 33)

3333

Chapter 6 BIOS SETUP UTILITYChapter 6 BIOS SETUP UTILITY

Chapter 6 BIOS SETUP UTILITY

6.16.1

6.1

IntroductionIntroduction

Introduction

This section explains how to use the BIOS SETUP UTILITY to configure your system.

The BIOS chip on the system stores the BIOS SETUP UTILITY. You may run the BIOS

SETUP UTILITY when you start up the computer. Please press <F2> or <Del> during

the Power-On-Self-Test (POST) to enter the BIOS SETUP UTILITY, otherwise, POST

will continue with its test routines.

If you wish to enter the BIOS SETUP UTILITY after POST, restart the system by

pressing <Ctl> + <Alt> + <Delete>, or by pressing the reset button on the system

chassis. You may also restart by turning the system off and then back on.

Because the BIOS software is constantly being updated, the

following BIOS setup screens and descriptions are for refer-

ence purpose only, and they may not exactly match what you

see on your screen.

6.1.16.1.1

6.1.1

BIOS Menu BarBIOS Menu Bar

BIOS Menu Bar

The top of the screen has a menu bar with the following selections:

Main To set up the system time/date information

OC Tweaker To set up overclocking features

Advanced To set up the advanced BIOS features

H/W Monitor To display current CPU/MB temperature & Vcore voltage

Boot To set up the default system device to locate and load the

Operating System

Security To set up the security features

Exit To exit the current screen or the BIOS SETUP UTILITY

Use < > key or < > key to choose among the selections on the menu bar,

and then press <Enter> to get into the sub screen.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 47 48

No comments

ASROCK 3D Owner's Manual Page 33